Putty can be used as a paint thinner, but there are several other uses for it.
Some of the more popular ones include: a glazing layer for roofing (this can be made from a thin layer of polyurethane) to help seal out fumes or other odours from a car (also from a polyuretha rubber) to seal a window (used for door handles, etc.)
to make a window sealer (to seal in water or vapour) (the use of a window can be hazardous) a coat for exterior doors to make a weather sealer (for interior doors) as a finishing coat for window curtains to help protect them from the elements (you can buy paint thinner made from polyurethene rubber for that purpose) (or for interior doors, you can use paint thinner for a coat of paint) for exterior doors to add decorative detail to your car, such as an opening for a sunroof (these can also be made of polythene plastic, but it will take more paint)How to get puttyThe process of making car glazing Putty is pretty simple.
You need: a glass or ceramic pan to coat the outside of the car with the glazing compound (such as a transparent glass) and (you can get these at most hardware stores or online) a rubber mat that can be rolled up and used to seal the plastic.
There are different types of rubber mats, but all are made to be rolled into a shape that will be perfect for glazing.
If you are making a plastic car glaze, you will want to make the plastic sheet with a layer of glue on it, and then use a plastic-mesh glue gun to roll the sheet up.
Once the glue is dry, you need to apply the glaze on top of the plastic to seal it.
Here’s how you do it:Put the plastic on a flat surface.
Make sure you cover it up with the glue.
Take the glue gun and roll it down the side of the pan.
Once the gun is rolled down the pan, you’re going to have to use a little bit of your finger to press it against the glue to get it to stick.
Make sure that you press it firmly against the plastic as you roll it.
The glue is going to stick to the top of your plastic sheet, but you want it to be a bit loose so it doesn’t go flying off.
If it does go flying, you may have to try and get it back in place with your fingers, or use a small screwdriver to push it out of place.
Now you’re ready to put it on the car!
Take your rubber mat and apply the glue as if you were going to paint.
Use your fingers to press the glue into the top corners of the rubber mat.
Apply the glue on top of the plastic, just like you did before.
You can now apply your final coat of glue to the plastic and finish it off with the final coat.
You can see in the picture above how the glue works to keep the glue stuck to the rubber.
The glue in the photo above is also a good way to seal in air.
It doesn’t need to be completely opaque to seal, but still needs to be very smooth.
You can also coat the top edges of the glazed plastic sheet in the glue, if you’d like to add a little more detail.
To get the best results, apply the final coating first, then move on to the next coat.
After the last coat, you’ll want to let the glazes dry a bit to remove the glue from the plastic surface.
For more detailed instructions, you could also try using a paint roller, but for this example, I’ll just do a few simple tricks and post up a video on how to do it.
I hope you found this article useful.
Feel free to comment if you have any questions or comments.